Time Killers PCB Questions

[atari_overlord]

Howdy all. I just purchased a "working" Time Killers PCB and it seems to be having a few problems. I was wondering if anyone else has this PCB or if anyone knows where I can get a free copy of the manual. It kicks on and will run fine for a feew minutes and then reset again like I just turned it on. I kind of think its a power issue. My Jamma harness only has wires for 1 +5 and 1 +12 so that is all the power I am giving the board. Does anyone know if I need more?

[Flack]

http://coinop.org/kb_dl.aspx/kb/pinouts/time_killers.txt

That's all I could find (has pinouts, but nothing else).

Sounds like either a cap problem or a power supply problem. Good luck!

[Sylentwulf]

Could be a cold/bad solder. Whenit heats up it loses it's connection, and bap. Reset.