Any arcade collectors here? Is so, Here's some parts FA

[lancelet's cousin]

Some good stuff going up on Ebay...




I set the auctions to start in a few hours. So if you don't see anything it's because I posted this a little early.

My first auction is for 4 JAMMMA PCB's*, marquees for 3 of them (I left out throwing in the Break-Thru marquee because it was just too faded):

Bloxeed+self-adhesive marquee and monitor bezel

Capcom Bowling+marquee-I have the original "hook" buttons but for some reason left them out of this lot, maybe because the trackball sucks and I didn't include that either. The same story goes for my next PCB listed...

American Horseshoes+marquee

Break-Thru
-----------------------------------------------------------

My next auction is for a Williams to JAMMA adaptor. This was in a Joust cab with break-thru.
------------------------------------------------------------

Another auction is for a nice Zaxxon Marquee
--------------------------------------------------------------

And then two seperate auctions for populated Control panels:
Pac Man
Rally-X
------------------------------------------------------------------

And soon I will put up an auction for a rare Super Moon Cresta marquee. Plus a few Konami-class PCB's with a wiring harness for them will go up FA in a lot sale soon.
------------------------------------------------------------------

All this was in a barn for 10-15 years, so it should all be original.

*as stated in my auction, I am having problems getting sound in my one JAMMA cab. All 4 PCB's have been tested and working up to the sound part.

[lancelet's cousin]

OK, now they're on Ebay.

Sorry for the delay.

[maxlords]

What Konami stuff? I colllect arcade stuff, but I don't buy ANY off eBay

[lancelet's cousin]

What Konami stuff? I colllect arcade stuff, but I don't buy ANY off eBay

I haven't cleaned these yet (I need to remove the IC's and clean them) but here are the Konami games I was talking about:
Time Pilot -working
Time Piilot '84- I don't believe these are the same pinout as the standard Konami-class PCB, so this is untested
Super Basket Ball-working, but the sprites are ghosted
Mat Mania-jumbled graphics
Tag Team Wrestling-working

I have over 20+ mainly non-working arcade cabs and just don't have time to go through all of these, so I haven't done anything with them yet except plug a few into my TP cab. I really need to pull the IC's from my bad ones and clean the contacts. I was going to do that before selling them, or sell them as-is with the wiring harness as a lot on Ebay.


I was going to put them all on a single auction, since I'm tearing down the bad cabs (most of them) and parting out those due to serious space issues.

[lancelet's cousin]

I need to clarify something that has been brought to my attention via E-mail>

I've confused some people due to my username. I post as "Lancelet's Cousin" on a few boards. When I found all these cabs I posted first on KLOV's forum and this one. But KLOV didn't allow that many characters so I am just lancelet on KLOV, BYOAC, and the newsgroups. I'm not the cousin of the other guy posting, its all me.

FYI, a lancelet is the closest invertabrate relative to vertabrates. Thus, lancelet's "cousin".