Fianally finished my toaster hacking.
Here's what I did.
1.took it apart down to the motherboard.
2. soldered a new straight connector (like one from a genie) straight to the motherboard (where the old 72 pin attached)
3. Flipped the motherboard over and put it in upside down. (used spacers and 4 bolts and attached it to the top instead of bottom half of the case.
4. Drilled holes in the front for the power, rf ,and rca.
5. Had to extend the 1st player controller wires so they would reach the connector on the motherboard.
6. Cut out a small section below the original cart door so carts would now fit.
7. Put it back together , hooked it up , Works perfect First Time , Every Time.

P.S. I know it's not perfect. If I do another one it will look much better. I think i can attach the motherboard without the bolts showing. There were a lot of mistakes made with this one.
I needed something to test games with , so I would KNOW FOR SURE if the games needed cleaning , or the NES.

http://members.aol.com/jonjandran/nes.jpg
http://members.aol.com/jonjandran/nes1.jpg