1st time real mod project

[RadiantSvgun]

I'm going to purchase my own soldering iron tomorrow. I'd like to learn how to do mods and stuff, but to start out simple, I'd like to try to mod a Model 1 genesis for true stereo output via the headphone jack. Any instructions, or is this too hard for a beginner? I'm not too worried about the genesis, as I have another one, and an X-eye.

I say its a real mod project, since I have to use a soldering iron.

[77punk]

its really not hard at all from what I remember. Just make sure you have some circuitry to try soldering to first off. It makes things easy and remember to use the flux and use the solder sparingly. I used tape to cover the area and mark it before I drilled and used smallest to larger drill bits to not break the shell of the system. Take you time and have fun. This place rocks for advice as well..

Look here for advice..

http://www-unix.ecs.umass.edu/~dhowland/mod/

good stuff to do when your in screwing around and very detailed.

[pabloescobear]

Is this your first time soldering? It takes a little practice but it shouldnt be that hard. I started off by replacing some LEDs and fixing the controller ports on my Genesis 2s.

Below is the post that I started on the topic.

http://www.digitpress.com/forum/showthread.php?t=115680

It mentions that I will put pics up...too bad I havent been home to work on that project since April. Stupid work...

[RadiantSvgun]

Is this your first time soldering? It takes a little practice but it shouldnt be that hard. I started off by replacing some LEDs and fixing the controller ports on my Genesis 2s.

Below is the post that I started on the topic.

http://www.digitpress.com/forum/showthread.php?t=115680

It mentions that I will put pics up...too bad I havent been home to work on that project since April. Stupid work...

Yeah, its my first time. I won't start until next week, I'm trying to get information on the parts I need. My friend is going to donate some dead arcade pcbs for me to practice soldering. LED modifications is something I would love to do, but I think that might be beyond me at this point. Where do you guys go for your parts? Radio Shack?

[pabloescobear]

I went to Radio Shack to get most of my supplies. LEDs however I bought on eBay. It was like $3 for 50 where they are like $3 for 2 at Radio Shack. I also bought a cheap volt meter in order to check resistances and whatnot. It ended up being very helpful when I burned out sections of my circuit board and had to re-wire it.

If you want to do LED modification, the Genesis 1 is the easiest thing to do it on. All you may have to do is enlarge the hole that it sits in and change out the LED. There is no soldering required at all.

[RadiantSvgun]

Cool! I might as well try to do a composite mod too. I'll tackle a region mod later.