PAL SNES to SONY PVM 2950 - Help!

[theMot]

Hi Guys,

I need to clarify something. I have picked up a Sony PVM 2950 and I want to connect my PAL Snes to it. I have ordered one of these: http://www.retrogamingcables.co.uk/s...-convertor-bnc as the Sony PVM only has BNC connector for RGB.

Can I just buy a regular PAL SNES SCART cable and connect it to that or will the cable also need an LM1881 chip to work?

Thanks

[APE992]

I don't see any need for a sync stripper here so long as you're using a PAL SCART cable made by Nintendo. Worst case you might have to rewire a SCART cable a bit but you'd only know after you hook everything up.

Why in the world did you think you'd need a sync stripper?

[theMot]

I was having someone make me a cable and their putting an lm1881 on the cable. He did a cable like this for me before for a commodore 1084s monitor cause it needed it. Not sure if its the same case with the sony pvm.

This is all very confusing for me

[APE992]

It is still confusing for me and I do RGB mods. The LM1881 might be necessary if the display you're using cannot use composite video for the SYNC source or C-SYNC if it is available. From what I've seen on N64 RGB mods is that C-sYNC works best in terms of picture quality but most displays seem to find both usable. I'd imagine it is similar with SNES RGB output.

[theMot]

Yeah, im not too sure. Really need someone who uses a pal snes on a sony pvm to confirm.

[ApolloBoy]

You don't need it for a PVM, the SCART cable I use for my SNES mini and Super Fami works fine.

[theMot]

I didn't think the snes mini did rgb?

[ApolloBoy]

I didn't think the snes mini did rgb?

Not unless you mod it, it's very easy to mod for both RGB and S-video.