it works fine. Did an okay job, though the underside looks pretty scratched. I tried sanding the plastic even, but one end was cut at a band angle. From the back end attached, it looks weird, but form the front, it looks pretty normal. The 'POWER' hole on the Genny 2 at the same place as on the Genny 1. Anyways, here's my concern.
The whole PBC seems to hover over the Genny 2 casing about a half an inch, obviously because the cartridge slot is deeper on the Genny 1. The PBC fits in snugly, but it is wobbly from front to back. This is a bit of a concern, as I don't want to bed or break the pins on Genny from it being able to rock back and forth. The only thing I can think of is to glue on a hunk of plastic underneath the PBC to keep it stable. So I get this idea, and I'm wondering if it would work. From what I recall, the 32X fits flush with the Genny 1, but there's a spacer that comes with it that allows it to be flush with the Genny 2 (correct?). So if this is the case, and considering that the PBC fits snugly with the surface of the Genny 1, could I use the 32X spacer with the PBC to make it snug with the Genny 2?